Intellitronix, DP6016T, 1963-1972 Jeep Wagoneer/J Trucks/Jeepster Commando LED Digital Gauge Cluster Teal LEDs, Oil Press, Temp and Speed Sensor Included
Features:
- Speedometer: Reads up to 255 MPH and features odometer, trip meter, one-button calibration (compatible with any tire size, gear ratio, or transmission), 0-60 time, 1⁄4 mile elapsed time, and high-speed recall-all controlled with a single button. It works with electronic cruise control senders or the included S9013 speedometer sending unit for vehicles without functional cruise control.
- Tachometer: This cluster is equiped with a speedo/tach combo. Reads 0-9900 RPM in 100 RPM increments. When in tachometer mode, RPMs will read out in the sweep and odometer.
- Water Temperature: Displays a range of 100-300°F and includes the S8013 sending unit. If you need a 3/8 inch bushing instead of the standard 1/2 inch, just specify at checkout. Otherwise, the correct bushing can be sourced separately.
- Oil Pressure: Reads 0-100 PSI with the oil pressure sender included. *adaptor not included
- Voltmeter: Displays a 7.0-25.5 volts range, no sending unit required.
- Fuel Level: Displays 0-99% in 1% increments and works with your existing Jeep fuel level sending unit.
- The panel also features brake indicator, check engine light, turn signals and a high beam indicator.
1963-1972 Jeep Wagoneer/J Trucks/Jeepster Commando LED Digital Gauge Panel - DP6016
Upgrade your 1963-72 Jeep Wagoneer, J-Truck, or 1967-73 Jeepster Commando with an eye-catching LED Digital Replacement Gauge Panel from Intellitronix. This digital dash comes complete with direct-fit printed circuit boards, custom-fit "smoked" plexiglass faceplate, and universal temperature, oil pressure, and speedometer sending units, along with sensors for vehicles without electronic transmission or cruise control. Easy-to-follow instructions for installation are also included.
The digital dash works with your factory fuel level sending unit and cruise control sender or electronic transmission output, if equipped. Everything fits directly into your existing housing, though wiring may be required for the speed sensor.
